Hardware and methodical complex for the pump installation applied to repair and insulating works of AMK URIR-40
- Customer pickup,
- Courier
- In detail
- Country of manufactureRussia
The URIR-40 installation M is intended for preparation of cement mortar and other technological liquids and their pumping in a well. Assembly base is the chassis of the URALS car 532362-1022. YaMZ-7601.10 chassis engine, power of p/a (kW) 300 (220). On installation are mounted: The pump of a high pressure three-plunger NGP-727A with the largest power consumption of p/a (kW) - 160 (118) with the drive from the power AC-110K (YaMZ-236) unit. The largest developed pressure of kg/cm2 (MPa) with a diameter of plunger of 100 mm - 400(40). The greatest giving, dm3/s (with a diameter of plunger of 125 mm) - 18,85 Pump the water giving ODN 120-100-65 Giving, m3/hour (l/sec.) 27-54 (7-15) Pressure, m - 13 … 8 Drive of the pump - hydraulic Buck, m3 - 4 Osrednitelnaya capacity capacity no more, m3 - 10 Type of mixers - screw the Drive of mixers - from a box the HOUSE of the automobile chassis via the driveshaft. Overall dimensions of installation (length, width, height) of mm - 11000х2500х3900 Producer of LLC Stromneftemash Na the equipment URIR-40 accommodate the hardware and methodical AMK.URIR-40 complex of a design of LLC Burgeoservice +. To the high-pressure line of pump installation elements of a measuring insert IV-32 are mounted: RGR-100(M) flowmeter, measuring devices of pressure ID-40, T-40. In osrednitelny capacity the KP-PUT(P) complex device for measurement and regulation of density of the prepared liquid, its level (volume) and temperature is mounted. For duplication of measurement of density of the prepared solution in the course of its downloading in a well, at the request of the Customer, to the pressure head line the GPRM densitometer can be installed. Control of measuring devices can be exercised by means of the SKUPTs-K station mounted in inside of the crew URALS 32551-0010-11 bus or by means of the SKUPTs-K(M) small-sized station. SKUPTs-K (M) is mounted in expanded, at the expense of a berth, a cabin of the driver of the chassis of the URALS car 532362-1022 on whom URIR-40 is mounted. The power supply unit of SKUPTs-K(M) station functionally and practically does not differ from similar, used for SKUPTs-K station. But it is built in in the small-sized case and settles down behind sitting of the operator (the passenger of the car). The measuring block and system of collection of information have a certain difference from used in SKUPTs-K connected with the fact that in SKUPTs-K(M) the interface of communication of RS-485 and NOTEBOOK is used. The SKUPTs-K(M) measuring block is placed over the head of the operator who takes the place of the passenger, NOTEBOOK settles down before the operator on a special support. It has a certain degree of freedom of movement that allows the operator to carry out the convenient NOTEBOOK installation.
