- Country of manufactureRussia
Prices are indicated without VAT
REDINGTON RUF - IN
1 - component polyurethane waterproofing.
REDINGTON RUF - B is a 1 - component polyurethane waterproofing mastic. Apply by brush, roller or airless spray as a seamless finish. It polymerizes (dries up) upon interaction with moisture in the air, forms a strong and highly elastic vapor - permeable membrane. Repairable. UV resistant. Color: Gray.
Packing: metal buckets with a volume of 25 kg.
Top layer in two - layer waterproofing systems for flat roofs
Waterproofing of wet rooms, toilets, bathrooms, basements, technical floors
Stadium stands, terraces, verandas, balconies
Other insulated substrates exposed to UV
Application by roller, brush or airless spray.
Forms an integral, seamless membrane when applied.
The finished coating is resistant to constant contact with water.
Retains its properties in the temperature range from - 40 ° C to + 90 ° C
Creates a vapor - permeable coating
In case of damage to the coating, it can be repaired with RUF - V or PARAPET
Before application, the contents of the can must be thoroughly mixed to a homogeneous mass using a low - speed mixer (150 - 200 rpm) for 2 - 3 minutes. When applying materials by airless spray, add REDINGTON Thinner (maximum 5% - 7% . ) To reduce the viscosity. Then apply the material on the dried bottom layer of waterproofing REDINGTON RUF - N, or on a pre - primed surface with a consumption of 0.7 - 0.9 kg / m² - when applied with a roller or brush and with a consumption of 0.75 - 0.9 kg / m² - when applied by airless spray. The finished coating should be uniform and completely cover the bottom layer. If you need faster drying in cold weather or limited installation time, it is recommended to use the REDINGTON accelerator.
|Coating type||1 - component polyurethane||Consumption per layer||0.7 - 0.9 kg / m²|
|Density||1.40 (± 0.05) g / cm³||Elongation at||> 500% (ASTM D 412, + 23 ° C)|
|(ASTM D 1475 / EN ISO 2811 - 1, + 20 ° C)||break|
|Viscosity||3000 - 6000 cp
(ASTM D 2196 - 86 / EN ISO 3219, + 25 ° C)
|Adhesion to concrete||> 2 N / mm²
(TSE EN 1542, + 23 ° C)
|Vapor permeability||0.8 g / m2 hour (ASTM E96)||Accelerated test||> 2000 hours (ASTM G154)|
|Temperature||from + 5 ° C to + 35 ° C||Temperature||from - 40 ° C to + 90 ° C|
|Dry residue||85% (± 5)||Drying time up to||6 hours (25 ° C / 55% RH)|
|Hardness||> 60 (Shore A)||Re - time||6 - 24 hours|
|(ASTM D2240, DIN 53505, EN ISO R868)||coverings|
Information on all of the company's products can be viewed at https: // ugspecsnab. com /