- Country of manufactureRussia
Roller mill U10 - CB2, for crushing and flattening kernels of sunflower seeds and other oilseeds.
The destruction of seed kernels increases the yield of vegetable oil.
The main parameters and dimensions of the roller drum are shown in the table:
|No.||The name of indicators||Unit rev.||U10 - SV2|
|1||Technical productivity, not less, with a gap between brews|
|- 0.15mm||kg / h||1000|
|- 0.2mm||kg / h||1350|
|- 0.3mm||kg / h||2000|
|2||Drum rotation frequency||rpm||345|
|3||Installed capacity, no more||kWh||8.0|
|4||Occupied area, no more||m 2||1.0|
|five||Overall dimensions, no more|
|6||Weight, no more||Kg||1000|
Product structure and delivery set
Roller mill consists of the following main assembly units:
- right drive;
- left drive;
- working body mechanism;
Device and principle of operation.
The right - hand drive and the left - hand drive have the same design and are designed to drive the rolls into rotary motion using V - belts. Each drive consists of an electric motor, on the shaft of which a drive pulley of a wedge transmission is mounted, a sub - engine plate with a tensioner.
The mechanism of the working bodies is designed for crushing and turning the seed kernels into mint. It includes:
- Rolls - with bearings, which are the working bodies of the machine;
- Sheets - guides that serve to feed material into the gap between the rolls;
- Scrapers - designed to remove adhered product from the rolls surface;
- Device - tensioning of wedge gears;
- Pulleys - wedge gears;
- V - belts;
Oil seeds from the shop hopper with a metering unit are continuously fed to the guide plates of the first roll pass. At the first inter - roll pass, due to the difference in the peripheral speeds of the rolls and the presence of corrugations on their surfaces, the seed kernels are pre - crushed.
After the first pass, the product enters the flap, which guides it into the second pass, between the second and third rolls, which have a minimum gap.
Then the product enters the third passage, where its final crushing takes place, i. e. turns into mint. Further, the papa leaves the mill along the guide flaps.
To remove adhesion from the surface of the rollers