The power supply for plasma cutting of P-Tronic 25C

The small-sized inverter of plasma cutting with the built-in compressor. It is ideal for works in the conditions of small production and on installation.

Ignition of the cutting arch is made due to excitement of a pilot arch and opening of the air channel of a plasmatron. Lack of high-frequency system of ignition of an arch allows to eliminate influence on other equipment at the time of ignition of an arch, to raise a resource of account details of a plasmatron, gives good visibility of a working zone and allows to make contact cutting.

The modes are sharp:

cutting with a gap

contact cutting with a nozzle support on a metal surface

plasma a witness mark with a nozzle support on a metal surface

• For manual cutting
• Plasma-forming gas - air
• Smooth adjustment of current of cutting
• Exact installation of current of cutting and consumption of air
• Air supply after switching off of cutting for cooling of a plasmatron
• Big resource of account details of a plasmatron
• Connection of plasmatrons with the central Evrorazjyom
• Built-in manometer of pressure of air
• Built-in block of preparation of air

Technical characteristics of the power supply for plasma cutting of P-Tronic 25C
Rated voltage of food (B)	1х230
Rated power consumption, (kv-A)	3,1
Idling tension, In	460
Current of a pilot arch, And	13,5
Cutting current, And	7-25
Rated load (PV), %	PV OF 35% PV OF 60% PV OF 100%	25A 17A 13A
Pressure of compressed air, MPa	4,5 - 6,0
Thickness are sharp:	low-carbonaceous steel	stainless steel	aluminum
high-quality cutting	6 mm	6 mm	6 mm
dividing cutting with a punched hole	10 mm	10 mm	10 mm
cutting from edge of a detail	12 mm	12 mm	12 mm
Protection class	P21S
Overall dimensions, mm	420×190×430
Weight, kg	16,0

Standard complete set

• earth cable of 3 m
• TER-80 plasmatron, sleeve of 4 m
• set of account details: 1 electrode for cutting, 2 nozzles for cutting